• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Clutch Questions

Share this page

Rob Glasgow

Rob Glasgow

Jedi Knight
Country flag
Offline
I have two questions. Car is a BT7. What is the torque spec on tightening the pressure plate bolts to the flywheel? Also, how do you remove the pin that hold the throwout bearing yoke in place. I tried to drive it out using a punch through the hole in the bell housing but couldn't get it to budge. Any tips?
 
I don't ever remember being able to "drive" out the tapered pin, so I don't even try anymore...

IMG_7410.jpg


IMG_7413.jpg


IMG_7417.jpg


Blind bearing puller/slide hammer to remove bushes.

IMG_7419.jpg


IMG_7420.jpg


The slave mounting bosses, if not stripped out already, are destined to be; as a matter of routine, I always put inserts in them. I've never had one of them fail afterwards.

IMG_7425.jpg


IMG_7439.jpg
 
Back
Top