but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I just read this in an older Classic Motorsport magazine: "Another item affecting the system of arms and levers on the choke linkage is the horizontal bar between the two arms. If it's adjusted too short, it will hang up the jet on the front carburetor, if too long the rear jet hangs up in the "open" position causing rich running." What is the correct length of the horizontal bar supposed to be provided the slop is taken up everywhere else in the linkage?
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
TR2/3/3A Choke linkage again.....
- Thread starter karls59tr
- Start date
Share this page
I was thinking there would be a "spec" for the bar length that would be a good starting point as the force may not always be with me.
MD is speaking a truth the system is fitted with a lot of slop. These cars are basic and simple and each car can be a little different when setting a choke because of variance of length of choke cable and how far back the arms the are pulled to find the sweet spot. you need the slop or stuff will hang up.
Steve
Steve