• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Carb Cleaning

Share this page

Patton

Patton

Jedi Warrior
Offline
Some of the white deposits on my SU's have been immune to the powers of the Berrymans I soaked it in. I'm not sure what the white stuff is, but it's really on there. Here is a picture of one of the carbs along with the deposits I am talking about.

BN4SUTypeHRebuild06.jpg


I am thinking that the best way to clean it off, especially inside, is with a dremel and a soft wire brush. Any reason to say no to that?

Thanks
Patton
 
Patton, It's aluminum oxide. A soft wire brush and a Dremel tool will work OK. Make sure to at least wear a dust mask and safety glasses.
There are dedicated aluminum cleaners that will do the trick, such as AlumaBrite. I think the brush idea is the way to go. If you can find a can of matte finish clearcoat, it wont hurt to give them a light dusting afterwards, to inhibit any further growth.
Jeff
 
Patton, If you have access to a blasting cabinet, Disassemble the carb . Cover all openings with duct tape.
Lightly blast with a very fine glass bead (not sand) Looks Great , The damper pots or housings can be sanded with a fine paper to smooth them up, then buff on a wheel to shine em . Do not sand or blast insde the damper pot ! Bob G
 
Mine looked a lot worse than that, I glass beaded them inside and out and washed them in the parts washer THOROUGHLY. Reassembled with new gaskets and they work like new. Skip
 
Back
Top