-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Cam options for 1500?
- Thread starter Scott_Hower
- Start date
Share this page
aeronca65t
Great Pumpkin
Offline
Running the same Kent TH2 cam as Mark...in my race car.
Engine lives above 5000 rpm except on grid.
No cam bearing; directly on block. In 6 years, no excess wear that I can see (but oil gets changed every 2 to 3 hours).
Seems to be working well....with single carb, it will pull 101 mph with 3.9 final drive (according to onboard GPS).
Engine lives above 5000 rpm except on grid.
No cam bearing; directly on block. In 6 years, no excess wear that I can see (but oil gets changed every 2 to 3 hours).
Seems to be working well....with single carb, it will pull 101 mph with 3.9 final drive (according to onboard GPS).
G
Guest
Guest
Guest
Offline
How much compression/what pistons you running?