• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Cam lobe RE-measurements

Share this page

Morris

Morris

Yoda
Offline
Okay, turns out the weirdness I was getting with my prior measurements were, once again, opperator error. I used the technique HAP descirbed in a previous thread and got much better results. Stock travel for my cam is .240 for both intake and exhaust according to the info on Paul Tegler's site. My lowest reading was .240 and my highest was .244. I can only assume that some amount of that spread is due to opperator and equipment error (bought my dial on sale at Harbor Freight /bcforum/images/%%GRAEMLIN_URL%%/smile.gif ).

So do you still say chunk it?

Ps. Playing with my dial and magnetic base was FUN!
 
well, 0.004" spread ain't that much. Only thing I'll mumble is: lifter 'juggling' is an iffy proposition. You could luck out and get where you want to be with it. Ever play "Risk!"?

/bcforum/images/%%GRAEMLIN_URL%%/smirk.gif


RE: PS... It's good for a lot more fun: TDC hunting for "degreeing" the mill, rotor run-out, practical jokes... the list can go on. /bcforum/images/%%GRAEMLIN_URL%%/wink.gif
 
Back
Top