• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Bugeye clutch MC push rod length

Share this page

T

tdskip

Yoda
Country flag
Offline
Hi guys - lots of time and nothing to show for it today. Rebuilt OE dual master today and brakes came up fine but not the clutch. I am 90 percent sure something is off in the rebuild - which is annoying since it is simple and putting in and pulling it out is a pain - but just in case how long should the push rod be?

Thanks!
 
Moss Motors offers both pushrods. Most depends on your set up: For example, I have a BE, but a 1275 and a late model ribcase. These factors influence the length of pushrod you need. BTW: I put a small 5/16th socket at the end of the pushrod - everything works fine.

MXP
 
Can also put a 7/16 nut in the cylinder where the rod goes to make it a bit longer. I did that as a test and just left it.
 
From my saved notes

Clutch Salve Cylinder

Per Frank C. 1275 slave rod is 2-11/16" from the center of the hole to the end.
1275 it should measure 3" from the center of the hole to the end of the pushrod. The 948 and 1098 cars are only 2 1/2" long
 
I think you need to be careful when swapping push rods. I think there were long push rods and short push rods for different master cylinders. If you used the short rods in the long body, you got nothing. If you used the long rods in the short body, you got locked brakes.

Also, you might check that the piston is not stuck half way down the barrel.
 
Thanks guys - and Porter, yes this was originally posted due to improper piston travel in the bore. Turned out to be a known seal fit issue, so I'm good here now. I double checked my push rods with the info provided by Jim and I'm good on push rod dimension as well.

Thanks guys!
 
Back
Top