Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
MadRiver
Jedi Knight
Offline
Howdy gang,
I hope everyone is well. I've got a question about how fuzzy door seals are mounted on a BT7. The spot I have a question about is at the top of the rear door jam, next to where the tonneau bar hole/bracket is located. I know that the top of the seal is held in place with a small aluminum bracket that is mounted to a little wooden block covered with interior trim. At one point, I had collected some photos of how this arrangement looks, but alas, I can't find them.
Does anyone have a BT7 that would be willing to snap a couple of photos of this spot for me? I would be much obliged.
Thanks so much!
B.
I hope everyone is well. I've got a question about how fuzzy door seals are mounted on a BT7. The spot I have a question about is at the top of the rear door jam, next to where the tonneau bar hole/bracket is located. I know that the top of the seal is held in place with a small aluminum bracket that is mounted to a little wooden block covered with interior trim. At one point, I had collected some photos of how this arrangement looks, but alas, I can't find them.
Does anyone have a BT7 that would be willing to snap a couple of photos of this spot for me? I would be much obliged.
Thanks so much!
B.
