• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Brake Servo ?

Share this page

C

cyaker

Senior Member
Offline
Still in tear down and strip phase on my 73 TR6. Pulled the pedal box and brake servo and master cylinder along with clutch cylinder. I was thinking I would send the servo out for rebuild. But now I can see the seals and rear fork and wonder if it had been redone in the past. Seals look fresh, no signs of cracking; the fork still has golden anodized appearance. There were no operational issues with the brakes when parked about 15 years ago. It feels like I am getting some vacuum when pressing on the fork. Does anyone have methods I could use to check it? I will do a rebuild on the master cylinder and plan on replacing the clutch cylinder. The frame is complete and has all new brake piping and rebuilds at each wheel.
 
I hate to say this without knocking on wood but the TR6 brake servo seems to have a very, very long trouble free life. Also, if the servo acts up, it is not a major undertaking to replace. If you sue the DOT5 fluid, you don't have to be overly concerned about brake fluid running the new paint. The masters and slaves are a different story.
 
Vettedog: "TR6 brake servo seems to have a very, very long
trouble free life."

You mean there might be a component of the Crypt Car that DPO
Pedro has not buggered up and will cost me big bucks $$ to
replace?

Can this be true? I have had to replace everything brake
related EXCEPT the servo unit. Including the emergency
brake system 100%

regards,

d /bcforum/images/%%GRAEMLIN_URL%%/wall.gif
 
Tinster said:
Can this be true?
Click to expand...
I doubt it. If the MC has leaked DOT 3/4 into the booster, the booster doesn't last long.
 
Here is an article. Included is a method to test the servo. After all the work to rebuild a unit the author recommends sending it out.

Buckeye servo rebuild
 
My 250 had the original servo on it when I bought it, and after two years of regular driving, the diaphragm ripped. Rather than mucking around with it, I replaced it. Took about ten minutes, but I neglected to bench bleed the servo, so it took *days* to get air out of the system. However, I guess it lends credence to the idea that the brake servo lasts a long time. Mine had been on the car for 38 years.
 
Thanks for the input
I think the way it looks and feels, I will clean it up and move forward on to the master cylinder. I did have a fluid leak at the back of the cylinder, which peeled away the paint and created the only rust under in the engine bay. I have to confess I created additional work in that area when I lifted the body off there was one brake line I missed and pulled down that shelf like area below the cylinders. First I will strip the engine bay back to bare metal.
 
Back
Top