Offline
I've got some Girling type 16 PB metric TR6 front brake calipers. They are mounted on my Austin-Healey 100-6, and were supplied with custom flex lines that have a tendency to kink. I want to use the TR6 flex lines, which would have a smoother route.
There is a short rigid pipe, hose to caliper, metric thread, Moss 588-555. One end of this rigid pipe obviously screws into the caliper. Is this pipe supported anywhere else along its length to keep it from flexing? If so, how?
Thanks!
There is a short rigid pipe, hose to caliper, metric thread, Moss 588-555. One end of this rigid pipe obviously screws into the caliper. Is this pipe supported anywhere else along its length to keep it from flexing? If so, how?
Thanks!