Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Came back from Florida and started my TR6. It started ok after 4 months but the brake pedal was low and spongy. I checked the master cylinder and it was nearly dry. I filled the M/C with fluid but it needed bleeding and my brakes were very weak although they worked. I have never had brake fluid evaporate just from sitting in a heated garage for 4 months. Maybe a leaking hose?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
TR6 Brake fluid leak?
- Thread starter pdplot
- Start date
Share this page
Offline
I would look for a leaking cylinder or caliper. Could help to bleed, apply brakes for a bit to force the leak and then look for it.
Bob
Bob
Still waiting for my guy to come over and help me. I can't lay under a car anymore. I refilled the M/C reservoir with fresh DOT 4 and pumped the brakes many times. If there was a leak, the fluid should go down, right? It did not. Stayed right up to the mark where I filled it. Pedal got a bit harder but still spongy. No wet marks on floor. It might be leaking back into the booster? But the level would still drop, no? Also noticed the trim strip on the right rocker panel fell off and the top of the panel has pulled away from one end. Looks like someone did a cheapo repair some 30 years ago before I bought the car. Good old Bondo. The left panel is fine.
D
Deleted member 12064
Guest
Guest
Offline
Might be air still trapped, it doesn't take much. The best method I have used is the pressure at the MC way, but it is a bit of a pain and I use a MityVac. If you still have a PDWA, pull the switch connector wire and see if there is any fluid in the switch.
Offline
Interesting. Keep checking; if a whole reservoir "disappeared" in four months, you should see a drop in level within weeks.