brake calliper half seal size

[Hoghead]

I need to split the brake callipers and do not want to wait for Moss to ship me the little seal 583-820

I have googled and think it is .068 thick x .5 OD x 11/32 ID but would like confirmation as this is a critical part

Does anyone know the size of this little square seal

 

[PeterC]

Octagon will have it.

Peter

 

[RAC68]

Here they are from Pegasus (https://www.pegasusautoracing.com/productdetails.asp?RecID=1144) for $3.79 each + shipping.

All the best,
Ray (64BJ8P1)

 

[Hoghead]

Is that Pegasus part not for the 14 and 12 Girling or is the 16P on the BJ8 the same

 

[RAC68]

This part was referenced on a previous.

I have split the calipers to rebuild a few times and have had no problems. Just make sure you get new square profile O-rings from either British Car Specialists or Pegasus. Bolt them back together tightly and you're good to go.

I had no need to split my calipers and, therefore, have no personal experience. I would call Pegasus and ask them to verify their use on our calipers.

Good luck,
Ray (64BJ8P1)