Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
timbn2
Jedi Hopeful
Offline
okay... putting back together my steering column. Have a few questions:
1. regarding part #6 (o-ring), is there any special place they are supposed to go on the steering shaft, or are they just there as protection from rubbing the inside of the steering column?
2.where exactly is the felt bushing supposed to be placed? there is a metal ring about 6" down from the steering wheel splines on the shaft and a circumferential indentation in the steering column. is the felt gasket supposed to go between these two points?
3. the new felt bushing i got from moss is thicker than the old original one. (still usable, i have 2)is this just because it hasn't been compressed yet like the old ones?
4. the 6 washers that go onto the peg shaft are convexed, domed, however you want to describe them; anyway which way do they go one? do they need to be opposite of each other, or do they need to be all one way? does this make sense?
okay, i think that's it for now.
thanx
1. regarding part #6 (o-ring), is there any special place they are supposed to go on the steering shaft, or are they just there as protection from rubbing the inside of the steering column?
2.where exactly is the felt bushing supposed to be placed? there is a metal ring about 6" down from the steering wheel splines on the shaft and a circumferential indentation in the steering column. is the felt gasket supposed to go between these two points?
3. the new felt bushing i got from moss is thicker than the old original one. (still usable, i have 2)is this just because it hasn't been compressed yet like the old ones?
4. the 6 washers that go onto the peg shaft are convexed, domed, however you want to describe them; anyway which way do they go one? do they need to be opposite of each other, or do they need to be all one way? does this make sense?
okay, i think that's it for now.
thanx