• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BN2 Cylinder Head Stud Thead Size/Replacement

Share this page

B

bj8bn2

Member
Country flag
Offline
Anyone know the thread size for the cylinder head studs? I read in a previous thread that it's a good idea to run a clean-out tap into the stud holes when replacing the studs.

Also, can anyone confirm to lightly oil the studs and just get them finger tight or bottomed out - no need to torque them in.

Any other thoughts on replacing the studs?

Thanks
 
Back
Top