• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

BN2 Cylinder Head Stud Thead Size/Replacement

Share this page

B

bj8bn2

Member
Country flag
Offline
Anyone know the thread size for the cylinder head studs? I read in a previous thread that it's a good idea to run a clean-out tap into the stud holes when replacing the studs.

Also, can anyone confirm to lightly oil the studs and just get them finger tight or bottomed out - no need to torque them in.

Any other thoughts on replacing the studs?

Thanks
 
Back
Top