Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hi
I am just replacing the rear leaf springs on my early BN1
I have replaced the shackle bushes and pins. On re assembling and tightening the shackle pins firmly, the leaf spring can still move horizontally on the lower shackle by about 3mm. Is there supposed to be some slack here?
Also when I took the leaf springs off the rear axle was not perfectly aligned - the distance from front to rears of the drivers side wheels was different to that of the passnger side!
How is it best to get the correct axle alignment before doing up the ubolts. Is it sufficient just to centre the taper spacer on the spring central securing pin and then centre the axle attachment plate to this spacer?
Many thanks
Ian
I am just replacing the rear leaf springs on my early BN1
I have replaced the shackle bushes and pins. On re assembling and tightening the shackle pins firmly, the leaf spring can still move horizontally on the lower shackle by about 3mm. Is there supposed to be some slack here?
Also when I took the leaf springs off the rear axle was not perfectly aligned - the distance from front to rears of the drivers side wheels was different to that of the passnger side!
How is it best to get the correct axle alignment before doing up the ubolts. Is it sufficient just to centre the taper spacer on the spring central securing pin and then centre the axle attachment plate to this spacer?
Many thanks
Ian