• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Blasting and Welding needed in Greater Atlanta

Share this page

LarryKerr

LarryKerr

Freshman Member
Offline
Hi all

I have finally reached the point where I can think about getting the tub blasted and get new floor boards and the damaged cross brace replaced. I still haven't gotten the bondo off the fronts of both rear fenders so I may need patches on the fgenders and maybe sills.

Does any one have recommendations for media blasters in the atlanta area and for welders?

Appreciate any thoughts.
 
Larry,

I have tried stripping, bead blasting, sand blasting etc. the best that I have found is soda blasting. There is just no comparison!! Google - soda blast Atlanta. I saw an outfit called "Atlanta Soda Blasting Inc." there are also others.
 
Thanks, I will talk to them.

i have found a bunch on google and the phone book. I was really kind of looking for recommendations of places people have used that did a good job without beating the metal to death.
 
Larry,

Thats the beauty of soda blasting, it does not heat or distort the metal at all. In fact you can take a whole car and it will not etch chrome or glass.
 
Many years ago I had a Bugeye diped in Atlanta. It's and option.
 
Back
Top