• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

BJ8 Windshield seal

Share this page

O

oracle59

Freshman Member
Offline
Finishing the 9 year frame off restoration of my 65 BJ8 ph2. I am remounting the windshield and need some help. Prior discussions helped me determine that the Moss seal that I bought 8 years ago wasn't going to fit and led me to get a new one from British Car Specialists that fit much better.

Two issues though: 1) I cannot get the last 3 inches of seal where the channel curves to stay in the groove. 2) I believe the end of the seal needs to be folded around the edge of the fender near the pillar but I am not sure how.

I would appreciate any insight or photos that anyone can provide. thanks
 
Two issues though: 1) I cannot get the last 3 inches of seal where the channel curves to stay in the groove.
Most likely the eal was not stretched out initally try streching it a bit.

2) I believe the end of the seal needs to be folded around the edge of the fender near the pillar but I am not sure how.

Just fold it under the edge of the fender and use some trim adhesive if required to keep it i place.

I would appreciate any insight or photos that anyone can provide. thanks
 
Back
Top