Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Moss part # 147 or 470-655, the slider support assembly is the piece that sits under the hood latch support bracket. The slider s.a. has two nuts welded to the bottom. Anyway, there is a circular hole in the center of the slider support assembly where the striker pin fits. On the bottom side of that hole there is a tab on one side of the hole that extends about 1/4 of an inch. Question, should that tab be on the drivers or passenger's side on a LHD car? Yes, I even took pics when I disassembled the latch, but the tab being on the bottom side doesn't show in the pic.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
BJ8 Hood Release Mechanism
- Thread starter shorn
- Start date
Share this page
John Loftus
Darth Vader
Offline
Hi Skip,
I just installed these parts yesterday so it is fresh in my mind. I set mine up with the tab on the left side (driver side). I'm thinking the tab keeps the striker pin from slipping under this part when the slider pushes the pin to one side (because of the spring tension). This way when the slider is released, the pin is free to travel upward .. not catching on the edge of the sheetmetal. If you have the striker pin free you can play around with the mechanism to see how it works. I figured the tab would not be serving any purpose on the right side. If I'm wrong I'm sure someone will correct me.
BTW, it took me awhile to find it but there is small hole on the frame bracket for attaching the tension spring .. I've seen many Healeys with the spring attached all over the place. Let me know if you need a picture.
Cheers,
John
I just installed these parts yesterday so it is fresh in my mind. I set mine up with the tab on the left side (driver side). I'm thinking the tab keeps the striker pin from slipping under this part when the slider pushes the pin to one side (because of the spring tension). This way when the slider is released, the pin is free to travel upward .. not catching on the edge of the sheetmetal. If you have the striker pin free you can play around with the mechanism to see how it works. I figured the tab would not be serving any purpose on the right side. If I'm wrong I'm sure someone will correct me.
BTW, it took me awhile to find it but there is small hole on the frame bracket for attaching the tension spring .. I've seen many Healeys with the spring attached all over the place. Let me know if you need a picture.
Cheers,
John