• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BJ8 front kick panel attachment?

Share this page

J

John_Progess

Jedi Warrior
Country flag
Offline
I am doing the interior of my BJ8 and have questions about the front kick panels. I know the right front kick panel has two screws that attach the front part to the body and the rear vinyl extension glues to the body. The right side has the same type vinyl extension for the rear part but how does the front part attach to the body? Thanks for the help and have a good day!

John
 
Would you rephrase the question please--Keoke :frown:
 
Keoke,
Does the left side front kick panel attach to the body with any screws? If not what holds the panel to the body? Thanks and have a good day!

John
 
Hi John,

Yes the left side, driver side here in the US is held in with two screws.

One screw at the bottom near the highbeam switch.
One screw at the top near the fresh air vent.

The leading edge is held in place with contact cement and then the Bristel flex is pushed over it.

Roger
 
Back
Top