• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BJ8 door seal attachement point.

Share this page

B

BJ8TONY

Senior Member
Silver
Country flag
Offline
I am looking to find out where the rubber door seal (bristleflex) attaches to at the rear of the door jamb.
Does it attach to the aluminum shut face or to the body itself.
It has been about 6 yrs since I started this rebuild and some things seam like a distant memory but the end is near.

Thanks
 
The door seal attaches to the body flange (not the aluminum finisher plate), continues up to the top of the door opening and over onto the top edge of the rear upholstery panel. It is secured there with a small chrome clip (Moss P/N 240-530).
 

Attachments

  • IMG_0214.jpg
    IMG_0214.jpg
    51.5 KB · Views: 181
It does attach to the bottom aluminum finish plate correct??
 
Yes, there is no body flange along the lower door opening, so the seal attaches to the flange of the bottom finish plate.
 
Thanks for the feedback.
 
Back
Top