• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BJ7 Windshield-to-Body Installation

Share this page

M

mgbmga

Freshman Member
Country flag
Offline
I was unable to get the bottom seal from Moss to fit. The one from Healey Surgeons fit fine. My problem is when I install on the car the seal pops out when I try to get the seal to spread out toward wipers.

Any suggestions or video would be nice.

Mark
 
mgbmga said:
I was unable to get the bottom seal from Moss to fit. The one from Healey Surgeons fit fine. My problem is when I install on the car the seal pops out when I try to get the seal to spread out toward wipers.

Any suggestions or video would be nice.

Mark
Click to expand...
Be sure the seal is clean and the windshield frame “slot” is clean!
I used a drop of Super Glue Gel to hold mine. A drop of glue about every inch only on the affected area is all that’s needed.
You can also use the Gel glue to hold the door seal weather stripping in the areas it will not hold too.
 
Back
Top