• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

BJ -8 Exhaust Mounts

Share this page

B

Bock62

Member
Offline
Intermediate Exhaust Mounts on my BJ8 frame failed (rubber separated from steel angle brackets)and inspection showed they appeared almost new.
Car is new to me, has Ansa exhaust, and on installing two new sets of rubber mounts they seemed to be under a lot of tension.
Is this typical? Unique to Ansa? Any suggestions?
 
Hi David,
If you haven’t, you may want to try loosening the exhaust up at the flex pipes. If you have slip joints, they may have twisted when the exhaust was hanging.
 
Any pressure put on the clamps and the rubber will eventually separate. You may have to do some modifying with either the bracket or the postion of the exhaust. The fit should be, must be, stress free.

Happy motoring!
Roger
 
Back
Top