• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BJ-7 window rubber seal

Share this page

R

robert_ellison

Jedi Trainee
Offline
I just received replacement seals for my BJ-7 windows. They consisted of one long strip for each window. In the moss catalog it shows them as being 2 shorter strips, one on the bottom of the glass and one on one side. Is this the correct installation for this seal or does it stretch around the cutout where the vertical and horizontal rails are connected?

Robert
 
Robert,

Two strips but you may find the Moss glazing rubber too thick. You can try to use motor oil to lubricate, the oil absorbs into the rubber and swells afterwards to tighten the fit. If it is too thick you should be able to find thinner glazing rubber at an automotive glass shop (try to find one that has been in business a long time). It's also avail on-line but you need to order a bunch.


https://www.allglassparts.com/product/1139533693

Cheers,
John
 
Back
Top