• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Bent camshaft for 64 BJ8?

Share this page

J

John_Progess

Jedi Warrior
Country flag
Offline
The machine shop doing my engine tells me that the camshaft is out .004". Moss' camshaft lists for about $750. Is there a better place to purchase a new camshaft? What is the maximum runout allowed? Thanks and have a good day!

John
 
.004 is not much runout. I could not find a spec in my manual though I think it should probably be .001 or better. Still, a camshaft is very soft in bending and the bearings should easily force it into compliance when fitted.

I thought it was a common practice for machine shops to straighten a camshaft using two v-blocks, a dial guage, and a strong arm or 2X4. They need to measure the runout at each bearing to deduce where the bend is and then apply force to correct it.

Unless there are other problems with the shaft, suggest you look for someone who can straighten it.
 
Back
Top