• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Bench Press

Share this page

J

Jag240

Freshman Member
Offline
Hi folks,

I have in my possession a hydraulic pipe bender which works horizontally or vertically with the
ram part facing upwards like a bottle jack.

I had planned to use the bender as a bench press but it wont work with ram facing downwards.

Any ideas

Regards

Noel
hammer.gif
 
<blockquote><font size="1" face="Verdana, Arial">quote:</font><hr>The presses that I have seen leave the bottle upright & do the pressing with the bottom of the jack.<hr></blockquote>

That's how mine works.
 
Hello Noel,
it would seem that the oil reservoir is not feeding the pump section when inverted. That said why not use it horizontally, there is no reason for a press to have to work vertically. It may well be more fiddly if you are using spacers or the like but not impractical.

Alec
thirsty.gif
 
Back
Top