• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

bearing remounting

Share this page

tahoe healey

tahoe healey

Yoda
Country flag
Offline
I pulled the bearing to access the seal. Now I cannot get the bearing back in. It is 90% in but I cannot get it to seat against the seal. I've tied to use a vice but it just wont of the last 3 mm. Any suggestion? It came out with little trouble and I am reusing the same bearing. I'm thinking the torch.
 
I assume you cleaned the mating surfaces really well so you don't have a piece of grit holding you up. I also assume you are using the bearing spacer so you're pushing on the outer race. Have you tried rotating the bearing/hub in the vice in case it's somewhat cocked?
 
yep. I'm thinking dry ice as someone suggested elsewhere. Heating may distort the new seal. Hope I can find some at the local supermarket. I will try a friend of mine at a local auto re-builder tomorrow.
 
Back
Top