Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Superwrench
Jedi Trainee
Offline
Putting the wiring in my chassis on my 62 BT-7. Does anyone have a pic of the pos cable going through boot wall ? Thanks !
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Battery cable
- Thread starter Superwrench
- Start date
Share this page
andrea
Jedi Knight
Offline
My car is a 100 6 1958 BN4 and probably can be a little different from your I hope that photos can help you
https://picasaweb.google.com/lh/photo/_2Aj_P0yQaSGyost7SIG_g?feat=directlink
https://picasaweb.google.com/lh/photo/mLbx_InOeZm4sCbFPK2lYg?feat=directlink
and more thecnical photos in this album
https://picasaweb.google.com/112770819864514987162/DropBox
cheers
Andrea
https://picasaweb.google.com/lh/photo/_2Aj_P0yQaSGyost7SIG_g?feat=directlink
https://picasaweb.google.com/lh/photo/mLbx_InOeZm4sCbFPK2lYg?feat=directlink
and more thecnical photos in this album
https://picasaweb.google.com/112770819864514987162/DropBox
cheers
Andrea
OP
Superwrench
Jedi Trainee
Offline
Looks like the upper hole ? thanks !
RAC68
Darth Vader
Offline
If I remember correctly, the positive cable, in a negative ground car, initially passes through the near wall enclosing the gas filler pipe. From there it passes through the filler pipe enclosure and exits through the main boot bulkhead at the rear of the filler enclosure. From the boot bulkhead, the cable passes around the body at the top of the rear wheel differential area and down to the right side under the floor. Moving forward, it follows near the fuel pipe and terminates on the right side of the starter relay.
Hope that helps,
Ray (64BJ8P1)
Hope that helps,
Ray (64BJ8P1)
OP
Superwrench
Jedi Trainee
Offline
Ray , There are 2 holes on the wall in the filler pipe enclosure, I don't have a pic of which one it passed through. thanks !
Offline
RAC68
Darth Vader
Offline
Bob,
As far as I recollect, there is only 1 hole in the filler enclosure wall closest to the battery and one on the bulkhead at the back. The cable passes through both when traveling from the battery to the differential/wheel space. An additional hole, closer to the center of the bulkhead, is for the gas line.
If you have 2 holes on the filler space wall nearest the battery, then I suggest the additional was installed by a previous owner. Again, it is from memory that I am talking and was under the impression the BT7 was similar (if not exactly the same) as my P1.
Ray (64BJ8P1)
As far as I recollect, there is only 1 hole in the filler enclosure wall closest to the battery and one on the bulkhead at the back. The cable passes through both when traveling from the battery to the differential/wheel space. An additional hole, closer to the center of the bulkhead, is for the gas line.
If you have 2 holes on the filler space wall nearest the battery, then I suggest the additional was installed by a previous owner. Again, it is from memory that I am talking and was under the impression the BT7 was similar (if not exactly the same) as my P1.
Ray (64BJ8P1)
OP
Superwrench
Jedi Trainee
Offline
Thanks ! Guys ! 