• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Bad tach

Share this page

TypeRboy

TypeRboy

Jedi Warrior
Offline
Have any of you folks run across this..

My tach is reading way too high.. I would say about double what the motor is doing. The tach is new, and I'm wired for positive earth.

Any ideas? This read high from the word go after my rebuild was complete.. It didn't read normal then just jump to double...
confused.gif
 
Yes it's on the Elan.. It's running points..
 
You're probably aware of the problems Elan tachs have with electronic ignitions and some accesories depending on how they're wired, as well as the solutions. (If not, you can start at:
https://www.lotuselan.net/publish/bouncing_tach.shtml )

Is it possible the tach was altered at some point?

I think I have some material in hardcopy that I could look up and scan if you need it - mostly stuff that Lotus Ltd. has published over the years. Let me know & I'll look.
 
I do have an electric fuel pump, but it gets its power off of a pressure switch plumbed into my oil line, and grounds directly to the battery ( positive earth ) this cuts the fuel pump off when the oil pressure drops below 20 PSI. The tach is brand new and should be unmolested..

Maybe I will try my old tach to see if there is any difference..
 
Back
Top