• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

arc-brazing or mig-brazing

Share this page

eschneider

eschneider

Jedi Warrior
Offline
I'm currently using a MIG for most sheetmetal repairs, but I would prefer to braze.

I've read about some old-school arc-brazing tools, and now I'm seeing brazing wire for MIG's.

Anyone have experience with these?

Any brazing guys out there? Found any low-temp brazing rod that works especially well without distorting sheet metal?
 
That's just wonderful, AFTER I struggled to get all of the patch work done on the TR3, someone comes up with easier ways to do it, and a terrific web site devoted to this kind of work!

Makes me want to start all over again. /ubbthreads/images/graemlins/eek.gif
 
Back
Top