• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Anyone have a Pic of a Momo steering wheel on a 3?

Share this page

K

karls59tr

Yoda
Bronze
Offline
Did the Momo wheels from back in the day just tighten to the shaft by a bolt and could you mount the trafficter in them? Also are the TR3 and TR4A steering shafts the same ,in other words can you mount a TR3 wheel on a TR4A or vice versa?
 
Check this out:
https://cgi.ebay.com/ebaymotors/Triumph-T...sQ5fAccessories

I think the answer is 'no' across the board. IIRC the MoMo wheels used a application-specific hub that attached to the shaft using a nut, just like the original steering wheel. There were some other aftermarket wheels that would keep the control head, but again IIRC, not with the Momo. And I believe the R&P cars had a different fitting for the steering wheel than the earlier cars did.
 

Attachments

  • 25613.jpg
    25613.jpg
    33.6 KB · Views: 175
Randall That picture of the wheel on Ebay is why I posted here. Trying to determine if that is actually a Momo wheel and if it would fit a TR3? Do you think it is?
 
Back
Top