• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Anyone had experience with this vendor?

Share this page

Ray,
i bought a set early on and the stampings were really shallow, no stiffeners on the bottom, and the fit was a challenge. The vendor offered to refund 1/2 the cost if I would keep them, but they were returned anyway. I think he's a good vendor, but his product was not up to restoration standards.
Rut
 
not sure if same vendor, but will only buy from major supplier now, the set I purchased were warped, bent up bad.
 
I like the fact that they are made in USA.
 
Ray,
Thats the same company. Again, the stampings are very shallow and it would not be good for a restoration, but might be OK for rusty metal replacement if you have really good skills. You will need to use the rails from your old pans, drill and install any hardware, captive nuts, etc.
Rut
 
I've got a set of the good ones I will probably never need. I'd part with them for the same money!:encouragement:

Kurt.
 
Back
Top