Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
healeyboz
Jedi Knight
Offline
Could someone measure their crank pulley for me. Specifically from the back of the pulley to the end of the shaft that slides into the timing cover. Oh and the outer Diameter.
I think I might have the wrong one or something. The key slot for the washer is nowhere near fitting onto the key. Thoughts???
I get a weird vibration running about 50 mph all of a sudden and as soon as I give her a bit of gas or slow down the vibration goes away. I have also developed a leak from the rubber seal that goes around the pulley shaft. It has wobbled out. I believe that I recentered the timing cover around the pulley shaft when I originally built the motor, however, who knows. It is definitely centered now, I just need to figure out how far the pulley is supposed to slide in.
I think I might have the wrong one or something. The key slot for the washer is nowhere near fitting onto the key. Thoughts???
I get a weird vibration running about 50 mph all of a sudden and as soon as I give her a bit of gas or slow down the vibration goes away. I have also developed a leak from the rubber seal that goes around the pulley shaft. It has wobbled out. I believe that I recentered the timing cover around the pulley shaft when I originally built the motor, however, who knows. It is definitely centered now, I just need to figure out how far the pulley is supposed to slide in.