• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Alternator in generator case project?

Share this page

HerronScott

HerronScott

Darth Vader
Offline
Doug,

I was doing some web searching on various Lucas generator models and ran across a very expensive alternator in generator case option (too expensive for me!). I also found a post here where you were considering trying to do something similar.

Alternator in generator case

Did you ever get anywhere with this project?

Scott
 
Hi Scott, am I the Doug you directed this towards? (I assume so since I posted to the old thread!)

I started looking into making an alternator to look like a generator a while back but quickly ran into problems. The OD of typical alternator stators are simply a lot larger than the case diameter of the Lucas C40 generators. There are some very compact Denso alternators with small stators but they are somewhat expensive, particularly if your intent is to take them apart and use their parts inside a generator look-alike. There are also a few alternators available that require external control boxes... they are compact but parts for them didn't appear to be readily available.

I also considered getting a motorcycle alternator and re-packaging one of them. However, they are seldom rated in Amps. They are typically rated in Watts and no one seems to be able to tell you how fast they need to turn compared to a car's alternator... so I tabled that idea.

When I looked at buying steel pipe for this project (for the shell that would house the alternator components) that was rather expensive even before machining. In the end... I just gave up. There is the U.K. product which is horribly expensive. There are also the "similar" looking U.S. products from PowerGen. They are made for GM and Ford applications (and may therefore be too big) but they are about 1/2 the cost of the U.K. product. I didn't see how I would ever be able to find the right combination of components to keep the look and be cost effective.
 
Doug,

Yes, you were the one. :smile:

I was just curious if there was any more progress besides what you had posted in that thread.

Scott
 
Back
Top