Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
i am installing a heater valve in the water/coolent line in my 1500 mg midget. by adding this in air is going to be in the lines then. is there a way to get the air out before i start the engine so that all the air won't be running through it or will it work itself out someway quickly?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
air in water/coolent line
- Thread starter recordsj
- Start date
Share this page
Luke_Healey
Jedi Trainee
Offline
Run the car with the radiator cap off from cold. Let it idle until it hits the temperature the thermostat opens up.
As soon as the water pump is able to cycle water through the car, the air will find its way out of the fill hole.
Sometimes you need to be standing there to add more coolant to keep it full, as air finds its way out.
The way my Sprite radiator works with no overflow reservoir, there is always air in the system when it has cooled down. If you fill it full, it will blow some water through the overflow tube since the mixture expands when heated. That's normal in my case.
As soon as the water pump is able to cycle water through the car, the air will find its way out of the fill hole.
Sometimes you need to be standing there to add more coolant to keep it full, as air finds its way out.
The way my Sprite radiator works with no overflow reservoir, there is always air in the system when it has cooled down. If you fill it full, it will blow some water through the overflow tube since the mixture expands when heated. That's normal in my case.
Luke_Healey
Jedi Trainee
Offline
Well they all had such big radiators that a little air wasn't as big of a deal /bcforum/images/%%GRAEMLIN_URL%%/wink.gif Oh, and we didn't mind dumping chemicals out onto the roadway. It kept the roads looking shiny and new!
PCV on my 54 Ford is a pipe that runs from the crankcase to the ground, haha.
PCV on my 54 Ford is a pipe that runs from the crankcase to the ground, haha.
tosoutherncars
Jedi Knight
Offline
Just to confirm, the regular 'cap' on the 1500 is on the overflow tank, but there is a brass threaded cap in the centre of the engine block. You should be able to fill the rad without too many bubbles through the brass cap.
I believe that the manual calls for the overflow tank to be half full during initial fill. (Can someone verify?) Then, as noted above, close it up, run it until hot. Run the heater to ensure that the whole system is flowing, and top up as needed.
I believe that the manual calls for the overflow tank to be half full during initial fill. (Can someone verify?) Then, as noted above, close it up, run it until hot. Run the heater to ensure that the whole system is flowing, and top up as needed.