Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Had the drums turned and replaced the shoes on the rear brakes. After re-assembly, bleeding, etc., the RH side is fine but on the LH side when the hub extension is bolted down the drum doesn't want to turn freely. It turns freely before the bolts are tightened, the problem happens when the bolts are snugged down or torqued to ~70ftlb - same behavior. The drum still turns by hand but it is tight, not rubbing on the pads (they are chalked) and I can't detect any obvious source of friction.
Anyone seen this before? Any ideas what could be going on here or thoughts on what to look at next?
Thank you.
Chris
Anyone seen this before? Any ideas what could be going on here or thoughts on what to look at next?
Thank you.
Chris
