• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

A series Trans

Share this page

GB1

GB1

Yoda
Country flag
Offline
What is the max flywheel HP that can be put through a standard A series Rib Case?

Thanks
 
GB, I wouldn't want to pump more than about 150 through it, and even then, I don't think it would stand up for too long. Of course, this is only an opinion.
Jeff
 
What is the weakest link in the A series box?

The B series (MGA/MGB) gearbox is good for 200hp. (Maybe more)
There are some things that wear out before others but, don't really break. (Lay-shaft, 2nd gear syncro [early brass], tail-shaft bushing [early 1500] & input shaft bearing)
 
Thanks, Guys I took the lay shaft out and she was a beauty, so I replaced it w/o bearings and going in further.

I am looking at 90-95 at the flywheel and have heard that she wasn't good enough for over 100, so I wanted to check some experienced masters.

Thanks!
 
If you take it easy on the down shifts a stock ribcase can last a while. Once ya see bout 100 hp to the rear axle things will not work out so well with the stock gears.
 
Back
Top