• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR6 72 TR6 Speedo cable

Share this page

P

porgytirebiter

Freshman Member
Country flag
Offline
Speedo is not registering now. Have owned this one for 37 years and this just started recently. Have changed the cable, bounced for a little bit then died. How easy is it to change out the Speedo gear! Thanks,

Porgytirebiter
 
If you are talking about the right angle at the trans. not bad from under the car. It may be your problem there is a small piece that goes into the trans at the right angle that can brake. If you just slid a new cable in the old case and did not find anything wrong with the cable that angle would be likely the problem. If it is the gear assy in the trans it is all in the right angle assy and a new one is needed. Madflyer
 
Madflyer, thanks for your reply! My cable goes straight into the tranny through a single collar, not a right angle. I have looked up and seen the gear, but was looking for input to the ease or difficulty of installing it? I will most likely purchase the gear and housing and take on the task of attempting the install.

thanks again!
 
Back
Top