• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A 7/8" Slave cylinder? TR3a

Share this page

Lukens

Lukens

Jedi Warrior
Offline
I should have double checked before I ordered, but I ordered the 1" slave cylinder kit that is called for on my TR3a (TS-45693). I now see that I have a 7/8" bore. I'm assuming the previous owner put this on (perhaps to yield more travel?).
Question is would you try to find a 7/8" kit or order a complete 1" slave?
Russ

Edit: I see that the 7/8" bore, at some point, was replaced with the 1". Ordered 1"
 
I think you will find that tr3 is 1 inch. I tried a 7/8 on atr3 once and they are more difficult to push down. I favor the 1 inch.
 
Back
Top