Hi everyone, it's been a while! I am just now reassembling my BJ7 during my frame off restoration. Remembering what a chore it was to remove both the engine and transmission together early in the project, I decided to re-install the engine first and then the tranny, as the official repair manual suggests it is possible to remove the transmission alone. Has anyone actually accomplished this, and how? Trying to drop it in from the top doesn't appear to work because the starter housing on the tranny is too wide to fit through the opening in the firewall, and from below it would appear that you just can't do it with the engine and clutch assembly in place.
Any suggestions or words of wisdom? Thanks! Lance
Any suggestions or words of wisdom? Thanks! Lance