• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

2500M chassis tube question

Share this page

B

Bob60

Member
Offline
Been looking around for a 2500M. Found a possibility except a section of the drivers side outer chassis tube (the one that runs parallel along the door sill) is almost rusted through toward the front. The rest of the chassis appears solid.

Is it possible to repair this chassis tube without removing the entire body shell?

I'm not looking for that much of a project!

Thanks,
Bob
 
Bob,
Where in Virginia are you located? I'm in Roanoke.
You may be able to replace the tube without fully removing the body shell, but rather unbolting the bolts holding it to the chassis and raising it a bit. But,I caution that I have not done this so I would defer to those who have for more precise advice.
Good luck in your search for a 2500M, if I can be of any assist, let me know.

Marshall
 
Yes, you will be able to replace the tube with out removing the body. I would suspect that there are more than one tube that is faulty. Be sure not to heat the fibre glass too much, as it is highly flamable. Would weld a bit and stand to watch for any smoke/flame, ect.
Cheers, D.
 
Back
Top