Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
GTP1960
Jedi Knight
Offline
Fighting a cold, so not doing much on "Sheila"but after reading a few threads on motor mounts;
I decided to give it a try.
the mounts were in bad shape, possible the original ones, by the look of them.
after releasing the main nut,
i jacked up the engine by placing a 4x4 block On the jack, under the oil pan. I had just enough clearance to work the wrench on the 2 bolts of each baseplate, though it was difficult to get the back bolts, as they do not have a welded nuts.
After removal of the old mounts
I cleaned up the frame & repainted. Btw: Found the frame tag on a cross beam: "Z31".
i need to replace a couple of machine bolts, that took a beating during the extraction.
i am a little concerned about lowering the engine back down on the new mounts, as I haven't done it before & it looks like it is going to be a wrestling match.