• The Roadster Factory Recovery Fund - Friends, as you may have heard, The Roadster Factory, a respected British Car Parts business in PA, suffered a total loss in a fire on Christmas Day. Read about it, discuss or ask questions >> HERE. The Triumph Register of America is sponsoring a fund raiser to help TRF get back on their feet. If you can help, vist >> their GoFundMe page.
  • Hey there Guest!
    If you enjoy BCF and find our forum a useful resource, if you appreciate not having ads pop up all over the place and you want to ensure we can stay online - Please consider supporting with an "optional" low-cost annual subscription.
    **Upgrade Now**
    (PS: Subscribers don't see this UGLY banner)
Tips
Tips

2. Posting and Replies

Share this page

Basil

Basil

Administrator
Staff member
Boss
Online
A few points about posting topics and replies


0:00 Posting new topics (method 1)
0:38 Posting new topics (method 2)
4:10 - Posting video
 
Last edited:
vping

vping

Yoda
Bronze
Country flag
Offline
Pic Test.
20200528_153819 (1).jpg
 
vping

vping

Yoda
Bronze
Country flag
Offline
Pic Test 2
Bugeye resized.jpg
 
T

Tonopah Kid

Freshman Member
Country flag
Offline
1971 MGB, has Weber 32/36 DGV carb, I put a "rebuild kit" in it. Had some varnish in the bowl, I took out and cleaned and/or checked for blockages. Engine had problem before rebuild, would only run @ 2500 RPM, with Manual-Choke plates almost closed, 1/8" opening.
After rebuild installed, will start easily with Full Manual choke, and can be reduced to about 1500 RPM, (a little rough) still with Choke plates @ 1/8" What is going-on here?
 
vping

vping

Yoda
Bronze
Country flag
Offline
I think you may have posted this in the wrong thread.
 
OP
Basil

Basil

Administrator
Staff member
Boss
Online
Tonopah Kid said:
1971 MGB, has Weber 32/36 DGV carb, I put a "rebuild kit" in it. Had some varnish in the bowl, I took out and cleaned and/or checked for blockages. Engine had problem before rebuild, would only run @ 2500 RPM, with Manual-Choke plates almost closed, 1/8" opening.
After rebuild installed, will start easily with Full Manual choke, and can be reduced to about 1500 RPM, (a little rough) still with Choke plates @ 1/8" What is going-on here?
Click to expand...
Tonopah - you need to post this in our MG forum.
 
Top