-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
-
When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
1275 transmission throw out bearing
- Thread starter TRdoc
- Start date
Share this page
Offline
It should move freely but without play. It's a close fit and sometimes the tolerances are such that it can be tight. I doubt that it matters a whole lot, as it can be pretty stiff and still the stiffness is small compared to the forces on it, but you might want to loosen it up a bit just for good karma, if nothing else. Of course, be sure you have it together right.