1275 - Just HOW Do I Bleed the Slave Cylinder?

[AngliaGT]

Decided to eliminate the dead clutch pedal,& bleed the
slave cylinder.There is almost no room to get to it - I couldn't
even figure out what wrench works.
What's the trick to it?

- Doug

 

[Trevor Jessie]

I prefer to use a pressure bleeder. Wrench size depends on the slave, but most likely a 3/8.

 

[smaceng]

While the original bleeders were 3/8" as Trevor said, a new bleeder can be 10 mm!

 

[Jim_Gruber]

And access via port / hole in PS footwell.

 

[tomshobby]

The slave on my '76 is 7/16". I found both of these approaches quick and easy to use.