• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

100 Clutch Return Spring

Share this page

T

TodE

Jedi Hopeful
Offline
Can some body please help?? What does the end of the clutch return spring attach to? I know that one end attaches to the lever on the cross rod of the fork to the release bearing, but I can not remember what the other end attaches to? It does not show in the service manual. If you look at Moss it looks like it attaches to a small eye that attaches to the grease fitting on the clutch pedal rod. I do not think that is correct. For one the treads are not long enough on the fitting. If somebody has a picture that would be great!


Thank you in advance!

Tod
 
The little trapezoid bracket attaches to the bell-housing/engine plate. Use the bolt at the roughly 8 O'clock position when looking from the rear. The moss exploded view is a bit misleading as it doesn't show the bellhousing. No pic, sorry.

Bert
 
Hey Tod,
I will see if I can take a picture of mine and post it here if I can figure out how. If not I can send to your e-mail address.
Regards,
Mike
 
Back
Top