• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Door Pillar Pad Replacement

Share this page

E

esussman

Freshman Member
Country flag
Offline
What is the preferred process to replace the door pillar rubber gasket on my 1962 BT7?

Thanks, Eric
 

Attachments

  • IMG_0126.jpeg
    IMG_0126.jpeg
    2 MB · Views: 15
esussman said:
What is the preferred process to replace the door pillar rubber gasket on my 1962 BT7?

Thanks, Eric
Click to expand...
There are a couple of bolts holding each pillar that are accessed by opening the door and reaching under the dash. There is also the screw that shows in the photo. Remove all of those on both sides. Some pillars have shims between the pillar and inner fender. Note where they go when removing the bolts underneath so they can be properly replaced. When all the bolts and screws are removed, you at one end, and a helper at the other end can lift the windshield together and access the pads and replace with new pads. Reassemble.
 
Back
Top