• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Triumph TR3A 1st gear hub

Share this page

K

Kev888

Freshman Member
Offline
I have two first gear hubs and I’m not sure which one is correct for my triumph TR3A see photos . It appears that the inner hubs are the same, but the outer hubs have some differences.
 

Attachments

  • IMG_4104.jpeg
    IMG_4104.jpeg
    576.8 KB · Views: 126
  • IMG_4105.jpeg
    IMG_4105.jpeg
    513.3 KB · Views: 123
Should I assume that the interlock goes in the machined spline left photo and the spring and ball assemblies align with the right photo an interlock
 
I would suggest going by "feel" assemble with balls/springs and use the one that works best,
as it clicks in and out of neutral position. Inspect the balls for chipping too.
Mad dog
 
I do not think it makes any differance what one you use. I would deinatly replace the ball and springs on second gear becuase they keep it from popping out of second.
Steve
 
Back
Top