• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Installing engine with starter attached???

Share this page

P

paulsherman

Jedi Trainee
Offline
There is no dumb questions, so here goes. Can I install the engine (1275) with the starter attached? The books all show to remove the starter before removing the engine and to reinstall it the ass backward of removing.
 
The factory did it with ancillaries i.e.
starter, generator, and carbs aconnected but manifold sitting on top of engine so it would fit through frame rails. If you can get things high enough to get the angle to fit over radiator supports... In my garage w 7' ceiling I need to plan an install that goes between radiator support brackets or be able to ro car out of garage and into drivewAy that slopes sharply downhill.
 
Jim_Gruber said:
The factory did it with ancillaries i.e.
starter, generator, and carbs aconnected but manifold sitting on top of engine so it would fit through frame rails. If you can get things high enough to get the angle to fit over radiator supports... In my garage w 7' ceiling I need to plan an install that goes between radiator support brackets or be able to ro car out of garage and into drivewAy that slopes sharply downhill.
Click to expand...

My garage also has low ceilings, and my car was up on blocks. I pulled the engine separately from the tranny, and lifted it straight up. I've not put it back yet, not sure how hard it will be to mate the engine and tranny while they are in the car. But that is my plan.
 
Why do we all have low ceilings? I have a front tilt kit so bonnet has to be removed, radiator is out. Don't forget to hook up the drive shaft to the tranny before you install. As we all say, don't ask me how I know that.

Thanks everybody
 
Back
Top