• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Bugeye front frame rails

Share this page

Rut

Rut

Obi Wan
Offline
I know this has to be simple, but I can't remember what goes in the single threaded hole on the bottom of the frame rail, about 2" from the front.
Thanks, Rut
 
And how about the belt and suspenders to hold up the bonnet....i.e. two side supports + a prop rod. I was told that the prop rod should be used in case an up draft forces the bonnet upward, unlatching it, and it would come crashing down. Now really, what is the chance of that!!!
Scott in CA
 
HealeyRick said:
Funny, just this weekend I was talking to someone who told me the side supports slipped and the bonnet crashed down on them.
Click to expand...

I've had that happening to me. Wind in my part of the world is a part of life. The kind of supports on the bugeye unlatch quite regularly in gusty conditions.

One of my Sprites also shows unmistakable damage due to rear hinged hood flying up. Given the amount of damage it was probably while in motion, not from wind. Going to be a fun time to repair properly.
 
Here's a picture of the one I'm talking about with a bolt in it for visibility.
Rut
 

Attachments

  • image.jpg
    image.jpg
    189.5 KB · Views: 168
Rut said:
Here's a picture of the one I'm talking about with a bolt in it for visibility.
Rut
Click to expand...

I just assumed these were vestigial fittings used to tie the vehicle down during manufacturer to a jig, or during transport. For long time I thought they were part of the bumper mounting because neither of mine came with a bumper and it was years before I saw a bugeye with a bumper installed. If someone can tell us what they are for I'll have learned something.
 
The two holes in the bottom of the front frame, one of which Rut has a bolt in hold the sway bar rubber mounting bracket. Check the parts book for details, I have one but have never installed it.

Woops, looked at that again, the holes for the sway bar are behind the bolt Rut shows. Going to go look tomorrow.
 
Last edited:
Back
Top