• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A TR3 front brake line routing

Share this page

T

TexasKnucklehead

Jedi Knight
Country flag
Offline
I have a new set of brake lines to install on a clean frame (1958 wth Girling). The ones I pulled off were obviously not routed the same as original. Some looked like both ends were attached, then a foot was used to press the excess out of the way -not to mention extra couplers. I have printed out Don's right and left rear (thank you Don Elliott) and routed the front passenger side, but the drivers side is not as clear. I assume it goes up along the frame support rail, down and under the engine, then back up the rebound mount? Anyone have a picture?
 
Tried to send a set of pics but was told the file was too large.

Check your PMs
 
Tex-

Here's a few shots I took during the teardown which may help:
IMG_1306.jpg

IMG_1307.jpg

IMG_1308.jpg
 
JohnB said:
Tried to send a set of pics but was told the file was too large.

Check your PMs
Click to expand...
John ,
I’m having the same issue and I suspect the lines I got pre bent from classic tube may be upside down. Any chance I could get pm of the front left brake line routing? Thanks
 
Back
Top